Well Water Testing

Water Testing Study 2019:

Virginia Tech and UNC Chapel Hill offered free well water testing to any resident or business using a private well. The samples were analyzed for metals such as lead, copper, arsenic, and chromium. Water quality results helped develop a better understanding of well water quality in your area.

Test kits were distributed at locations Government Center South, Building Standards Statesville and Rocky Mount United Methodist Church from February 20, 2019-February 27, 2019. Any resident or business using a private well was eligible to participate. You did not have to live in the communities where pick up locations were available. There were a limited number of kits, so they were distributed on a first-come, first-served basis. Detailed sampling instructions were provided. Confidential water quality results were mailed to residents’ homes.

Water Testing Study 2019, The End Result:

In February 2019, Virginia Tech and the Institute for the Environment at the University of North Carolina at Chapel Hill partnered with the Iredell Health Department to provide free well water testing to private well users. A total of 786 well water sampling kits were returned for analysis (out of 931 that were distributed; 84% return rate). The goals were to measure lead in drinking water from private wells where well users are solely responsible for detecting and controlling water lead risks, and to examine well water quality and recovery after Hurricanes Florence and Michael. This sampling event was funded by the United States Environmental Protection Agency (US EPA) and the National Science Foundation (NSF).

The following conclusions are based on a preliminary evaluation of the samples collected by participating well users.

  • Of the 786 homes sampled, 7.5% of first draw samples exceeded the US EPA lead action level of 15 μg/L, which applies to regulated public water supplies. Elevated levels of copper above the US EPA copper action level of 1.3 mg/L were also observed in 10.8% of first draw samples. Although the US EPA Lead and Copper Rule does not apply to private wells, some of the higher levels of both lead and copper are concerning. Information about contaminants from household plumbing corrosion was assessed by letting the water sit stagnant for at least six hours, and then collecting the ‘first draw’ sample from the kitchen tap. After flushing water from the pipes for 5 minutes, less than 1% of homes had lead and copper concentrations above the action levels — this further confirms these contaminants were from plumbing. 
  • Other contaminants in well water come from the groundwater. Less than 2% of samples exceeded the US EPA health-based standard for uranium, and no samples exceeded the US EPA health-based standards for fluoride or total chromium. 
  • In North Carolina, the NC Department of Health and Human Services has set a health goal of 0.07 µg/L for hexavalent chromium, which is a concentration that is protective of people ingesting the water over a lifetime. There are no US EPA or NC Ground Water standards for hexavalent chromium. About 79% of homes had hexavalent chromium above the NC health goal, and the average concentration was 0.84 µg/L. Compared to hexavalent chromium measurements in private wells from other parts of NC and public drinking water supplies in the US, the Iredell hexavalent chromium test results do not appear unusually high. 
  • The NC Department of Environmental Quality has set an Interim Maximum Allowable Level of 0.3 µg/L for Vanadium. There is no US EPA or NC Ground Water standards. About 86% of homes had vanadium above the Interim Maximum Allowable Level. These vanadium test results from Iredell are similar to what we have measured in surveys of drinking water from schools outside of North Carolina.  

For more information and photos please visit:  http://www.uswaterstudy.org/projects/lead-in-water/iredell-county-north-carolina/